RP 3D
Harkness RP 3D rear projection screens are ideal for linear polarising passive 3D systems which require rear projection.
RP 3D is a flexible rear projection surface, specifically designed for "passive" 3D applications. It has an outstanding extinction ratio, and the transmittance gives sharp, bright images with an acceptable viewing angle. The material can be joined to make up large screens, and the seams are almost invisible.
- 3D/4D rides
- Simulators
- Education
| RP 3D | |
| Material | PVC |
| Colour | Dark grey |
| Weight | 0.43 kg/m2 (0.09 lb/ft2) |
| Thickness | 0.3mm |
| Roll width | 1.4m |
| Made up screens | Available |
| Packing method | folded |
| Fire classification | UK BS 5867 Park 2
France M3 |
- Web and eye (grommet) with 15cm (6") spacing
- Preformed pipe pocket any size on any side
- Cloth web and fixings (snaps) for press stud frames (UK only)
- Cut square (unfinished edge)
Screens should normally be transported and stored at temperatures between 5°C and 30°C (40°F and 85°F), with relative humidity less than 80%.
If screens are very cold (e.g. following air transport) then they must be allowed to warm up before unpacking, otherwise cold cracking may occur. Screens should be installed within a maximum of 2 months of shipping. Packages should be handled with care to avoid damage.
The general environment where the screen is installed should be kept reasonably clean to avoid dirt and dust build-up. Screens can be periodically cleaned using a soft brush or cloth, doing this vertically with limited pressure. Screens can be cleaned using a damp cloth wetted with water and a mild detergent. Under no circumstances should screens be cleaned with abrasive materials or harsh chemicals such as acids, bleaches or solvents. Harkness Screens is not liable for damage caused to screens through the use of inappropriate cleaning methods or chemicals.
For information on Installation, please see the Resources section of our website.
